3D Printing "Baby Yoda" from The Mandolorian
· 1 min read
Yesterday I printed a fun thing I found on Thingiverse, it was Baby Yoda from The Mandolorian Star Wars tv show (link to thing here). the first time I printed it I had scaled it down so small that it only took twenty minutes to 3D print, the next time I scaled it up and it took two hours to print, the end result was pretty good so today I painted it the colors of Baby Yoda. These are the settings I used:
Infill: 20%
Supports: Yes
Layer Height: 0.2
at the time that I am writing this, I am printing Baby Yoda's little floating crib!
(Above: My 3D print)
(Below: Baby Yoda)